If you want to know how to bleed Harley ABS brakes, you might think that you need to go to a dealer or a mechanic who has the special software and tools to do it. However, there is a way to do it yourself with some basic tools and a little patience. Here are the steps to follow:
1. Get all of the things you’ll need together. You will need a brake bleeder kit, a clear hose, a catch bottle, some DOT 4 brake fluid, a 10 mm wrench, and some rags.
2. Locate the brake bleeder valve on the caliper. It is usually on the top of the caliper, near the brake line. Attach the clear hose to the valve and run it to the catch bottle.
3. Open the master cylinder reservoir cap and check the fluid level. If it’s low, add more new brake fluid. There should be no empty space in the tank, or air will get into the system.
4. Loosen the bleeder valve slightly with the wrench. Do not remove it completely, or you will lose brake pressure.
5. Pump the brake lever or pedal several times until you feel some resistance. Then hold it down firmly.
6. While holding the lever or pedal, open the bleeder valve slightly and let some fluid and air escape through the hose into the catch bottle. You will see bubbles in the hose if there is air in the system.
7. Close the bleeder valve before releasing the lever or pedal. Repeat steps 5 and 6 until you see no more bubbles in the hose and the fluid is clear and clean.
8. Check the fluid level in the reservoir and top it up if needed. Do not overfill it, or it may spill when you close the cap.
9. Tighten the bleeder valve, remove the hose, and catch the bottle. Wipe any spilled fluid with a rag.
10. Repeat steps 2 to 9 for the other brake caliper if you have dual front brakes or a rear brake.
11. Test your brakes before riding. They should feel firm and responsive.
Congratulations! You got the answer: How to Bleed Harley ABS Brakes? and successfully bled your Harley ABS brakes without any special software or tools.
Read more: What is the anti-lock braking system (ABS) and how to use
